Campbell Hausfeld XT401000 Instructions D'opération page 9

oil and sharp edges. Replace any hose that is damaged, weak or worn.
10. Protect air lines from damage or puncture.
11. Never point an air tool at oneself or any other person. Serious injury
could occur.
12. Check air hoses for weak or worn condition before each use. Make sure
all connections are secure.
during first few seconds of operation after an airtool has been lubricated.
Failure to cover exhaust port can result in serious injury.
13. Keep all nuts, bolts and screws tight and ensure equipment is in safe
working condition.
14. Do not put hands near or under moving parts.
15. Always secure work with clamps or in a vise.
work motions can cause injury to hands and arms. Stop using any tool if
discomfort, numbness, tingling, or pain occur, and consult a physician.
Never carry a tool by the hose or pull hose to move
tool or a compressor. Keep hoses away from heat,
Release all pressure from the system before
attempting to install, service, relocate or perform
any maintenance.
This air tool requires lubrication before initial use
and before and after each additional use.
Cover exhaust port with a towel before applying air
pressure. Oil will discharge through exhaust port
Do not misuse this product. Excessive exposure to
vibration, work in awkward positions, and repetitive
7