Campbell Hausfeld XT401000 Instructions D'opération page 4

u For best output, maintain pressure at the tool of 90 PSI.
u The longer your air hose the greater the pressure drop from compressor to tool.
If you are using a hose longer than 50 feet, consider upgrading to a 1/2 inch ID air
hose to ensure proper tool pressure.
u Failure to lubricate and maintain your air tools properly will dramatically shorten
their life. Use oil every time you use your air tool to lubricate, clean and inhibit rust
in one step. Campbell Hausfeld sells air tool oil under part number ST1270.
SPECIFICATIONS
Maximum pressure (PSI)
CFM under load 100% duty
CFM no load 100% duty
SCFM under load 100% duty
SCFM no load 100% duty
Air Compressor Recommendation
Rated RPM (free speed)
Forward/Reverse Switch
Speed control
Drill Shank Range
Horsepower
Chuck Type
Gear Type
Air Inlet
Minimum Hose Size
Housing Material
Tool Weight
Tool Length
Tool Height
Tool Width
BEST PRACTICES
2
XT401000
90
4.0 CFM @ 90 PSI
4.6 CFM @ 90 PSI
29.1 SCFM @ 90 PSI
33.3 SCFM @ 90 PSI
26 gallon
2,000
Yes
Trigger
3/64 inch to 3/8 inch
0.36 HP
Keyless
Single Planetary
1/4 inch NPT (F)
3/8 inch
Composite
2.3 Lbs.
7 inch
6-3/8 inch
1-7/8 inch