Tools Needed - Pingi VIDA CSTV-1000EU Mode D'emploi

EN
VIDA CSTV-1000EU - DEHUMIDIFIER SET
BOX CONTENT
.
1.
2
. .
3 4
INTENDED USE
Your new Pingi Vida Dehumidifier set (CSTV-1000EU) is suitable for dehumidifying enclosed indoor spaces.
The appliance is powered by the 9V AC-DC adapter that is supplied with the device. The power adapter
operates on 100-240V, 50/60Hz (mains electricity). Never try to connect the device or power adapter to other
power sources. Please always follow the safety instructions in this manual. Keep this instruction manual in
a safe place, so that it is available at all times. This product complies with regulatory, national and European
requirements. Never try to make technical modifications to this device. We do not accept liability for
accidents or damages resulting from failure to follow these operating and safety instructions.
FUNCTION AND APPLICATION
The Pingi Vida Dehumidifier set (CSTV-1000EU) was developed as a compact dehumidifier set that captures
excess moisture in indoor spaces. This product is ideally suited for unventilated indoor spaces. The captured
moisture is collected in the integrated tank.
BEFORE YOU START
Please carefully read the safety instructions on the front page of this manual before getting
started.
WALL MOUNT INSTALLATION
6mm
This set comes with an included wall mount, model VSB-1S. Use of the wall mount is optional -
the appliance can also be used without it.
To use the wall mount, it needs to be securely installed on a vertical surface by means of 3 screws.
1. Select a vertical surface that provides sufficient distance to the wall mount and other objects.
2. Important: Make sure the power adapter cable can easily reach a nearby wall outlet before installing the
wall mount.
OK
3. Check if the wall mount hangs securely in a vertical position. Use a level if necessary to ensure it hangs
straight. Use a screwdriver to install the screws.
4. Before placing the appliance on the wall mount: Push the DC connector of the adapter through the
right opening underneath the wall mount. Optionally do the same with the drainage tube on the left side.
.
6
.
5
1. Dehumidifier
2. Wall mount (VSB-1S)
3. Drainage tube
4. Power adapter
5. Wall plugs and screws
6. Operating instructions
OK

TOOLS NEEDED

For wall mount installation only.
6mm
5. Plug the DC connector into the device. Optionally attach the drainage tube to the device. Now place the
appliance on the mount and make sure it is properly secured.
OPERATION
Powered on: The device is switched on by pressing the power button on the front of the device. The power
button will light blue. The blue tank light will also be activated. The appliance is now collecting humidity
from the ambient air.
Tank full: This appliance has an automatic shut-off function. When the tank is nearly full, the tank light will
change colour to red and the power button light will dim.
EMPTYING THE TANK
This device has a tank with a capacity of approximately 1000ml. When the tank is nearly full, the appliance
will automatically shut off its dehumidifying functions and the tank light will change colour to red. Switch
off the appliance and carefully slide out the tank by pulling its handle. The small cap marked 'DRAIN TANK'
located on top of the tank can now be removed. Empty the tank into, for example, a kitchen sink. After
draining the tank, it can be replaced. The device can now be switched back on.
24/7 DRAINAGE
This appliance comes with a convenient 24/7 drainage option. You can attach a 010mm drainage tube to
the tank and any collected water will flow out through the drainage tube. You can hang the other end of the
tube in for example a sink or large bucket. You will no longer have to empty the tank.
Tip: Do not throw away the cap. Save it for later use.
Blue light
10mm