6.
Add few drops of your preferred liquid fragrance (perfume, essential oil, or any other fragrance
that you prefer but in liquid form). Note: stirring is not required to mix the fragrance with water.
The Oscillator will break up the water and gives out better mixture. We recommend to use the
liquid fragrance products from professional perfume makers or drugstores which usually do
not content harsh chemical ingredients. Self-made fragrance products or fragrance in solid
form are therefore not recommended to be applied in your Difusor.
7.
Place the Inner Cap back onto the Base Unit.
8.
Place the Cover Cap back onto the Base Unit.
9.
Put the plug of Adaptor into the Adaptor Socket fully and properly.
10. Connect the Adapter with the main network supply.
11. Press the Control Button once, your Difusor will start working. After a few seconds you should
be able to see the mist coming out from the outlet and sense the smell of your favorite fra-
grance in your room.
12. Press the Control Button again and continuously, you will be able to change and select the color
of the illuminating light, or just switch of the light by pressing the Control Button again
13. Press the Control Button once more, the Difusor will be switched of completely.
14. If you do not want the Difusor in operation for a longer time, make sure to disconnect the
Adaptor with the main supply, empty and dry the Reservoir properly.
Important Notes:
•
Do not reill your Difusor without irst disconnecting from the main supply.
Empty and then resin the Reservoir properly before you change to another fragrance.
•
AUTOMATIC SWITCH OFF
Capacity of the Reservoir is 50ml. This means your Difusor can run continuously for approximately
3-4 hours with one full Reservoir. When the Reservoir is getting empty, the installed electronic sen-
sor in the Base Unit will sense the emptiness and then shut of the unit
CLEANING PROCEDURE
Your Aroma Difusor is a very reliable and robust product, its good performance however require
regular maintenance. The frequency of maintenance depends on how and how often you use it.
Depending on the water hardness, you may ind calcium and magnesium scales or other contamina-
tions left in the Reservoir covering the surface of the Oscillator. Therefore , you need to clean and to
descale your Difusor regularly, depending on the operating time.
To avoid lime scales
Use clean and softened water, cold boiled water, or distilled water.
•
•
Clean the Reservoir, especially the surface of the Oscillator weekly.
•
Dry the unit (Reservoir, Inner Cap, Cover Cap) completely with clean soft cloth after your use
and before storage.
Descaling and Cleaning
•
Switch of the unit by pressing the Control Button and disconnect the Adaptor from main supply.
•
Remove the Cover Cap and the Inner Cap, put few drops of white vinegar into the Reservoir,
let the vinegar cover the surface of Oscillator, and leave it for 5 minutes (the longer the better
cleaning results).
Clean of the scale with soft cloth.
•
•
Rinse all the parts (Cover Cap, Inner Cap, Reservoir ) with fresh clean water. Note: be careful
not to let water running into the Base Unit.
Dry all parts with soft cloth and put Inner Cap and Cover Cap back onto the Base Unit.
•
IMPORTANT:
Do not use cleaning agents or other scouring agents to clean the unit.
Do not use any metal or hard objects to clean the Oscillator.
10