Stylies Luna Mode D'emploi page 12

• The device must always be unplugged:
- before the device is moved to another place
- before the device is opened or when it is reilled with water
- in the case of malfunction
- before any cleaning
- after each use.
• Never use an extension cable that has been damaged.
• Never carry or pull the device by the power cable.
• Penetrating the housing with any kind of object is strictly prohibited.
• Use only the supplied adapter. If the original adapter is damaged, you can get a replacement but
only with and under the consultation with qualiied personnel.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualiied persons in order to avoid a hazard.
• Do not pull the power cable over sharp edges or allow it to become jammed.
• Never remove the plug from the socket by pulling at the power cable and never remove it with
wet hands.
• Do not use this humidiier in close proximity to a bath tub, shower or swimming pool (always
ensure a minimum distance of 3m). Always place the device in a position where it cannot be
reached by anyone in the bath tub.
• Do not set up the device near a source of heat. Do not subject the power cable to direct heat
(such as heat from hot oven hobs, naked lames, hot irons or heating furnaces). Keep the power
cable away from oil.
• Do not position the device directly next to walls, curtains or furniture.
• Ensure that the device is stable during operation and that no-one can trip over the power cable.
• The device is not splash-proof.
• Do not store or use the device outdoors.
• Store the device in a dry place and beyond the reach of children (in its box).
• Do not switch on the device when there is no water in the Reservoir.
• Do not ill the Reservoir over the «MAX» mark – too much water will disable the function of the
Aroma Difuser
• Do not use metal or hard object to clean the Oscillator.
• Do not use any harsh chemicals in the water Reservoir.
• Do not put the device into water, or let water get into the Base Unit.
• The mist and fragrance releasing part (the Outlet) should not be covered by other objects.
• Do not use the device in an area where the humidity level exceeds 60 percent.
• Never tilt, move, or attempt to empty the device while it is operating.
FIRST USE / OPERATION
Preparation:
1. Place your Difusor on a smooth, lat and stable surface.
2. Make sure that your Difusor is disconnected from the main supply.
3. Remove the Cover Cap and the Inner Cap.
4. Check and make sure that the Reservoir is clean and free of foreign objects.
5. Fill the Reservoir with maximum 50 ml fresh and clean water (recommended to use soft or
distilled water). Note: In order to gain optimal performance of your Difusor, please do not ill
water over the level marked «MAX».
9