SOLIS SWISS PERFECTION 443 Mode D'emploi page 29

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

• Never allow the air intake or outlet points to be covered!
• Always disconnect from main power after use and before
cleaning the appliance.
• Repairs to this appliance / including mains cable replacement
may only be carried out by authorised service agents. Improper
repair work can be a source of danger to appliance users.
• No liability for damage can be assumed and any guarantee will
be voided if the appliance is used for purposes other than the
one specified in these operating instructions, if it is improperly
operated or if repair work is carried out unauthorised. The hair-
dryer shall only be used with the nozzle that has been supplied
with the appliance or without any nozzle.
• To avoid the risk of cable breakage, do not wind the cable tightly
around the appliance (e.g. for storage).
HOW TO OPERATE
The two rocker switches can be used to select the following settings:
Appliance is
switched off
Motor runs fast
Heat level: warm
CLEANING YOUR DRYER
Before cleaning, disconnect the appliance from the mains. Never immerse the appliance in water.
Please remember to clean the air intake slot regularly with a brush to remove dust and hair from the
air inlet grill. You can clean your appliance with a slightly damp cloth and dry it with a soft cloth.
DETACHABLE AIR INLET GRID
The hairdryer is fitted with a detachable air-inlet grid. To free the appliance of sucked-in hair and dust,
remove the air inlet grid by rotating it slightly to the left. The air inlet grid can be cleaned with e.g. a
brush. When cleaning is finished, rotate the air-inlet grid back onto the hairdryer by rotating to the right.
The filter must never under any circumstances be replaced when wet. Never use the
hairdryer without air inlet grid attached. Regular cleaning will significantly prolong the service life of
your hairdryer.
968-75_SwissPerfection-Typ443-Betriebsanleitung.indd 29
Motor runs
slowly
Heat level: warm
Motor runs fast
Heat level: hot
Motor runs
slowly
Heat level: hot
Motor runs fast
Heat level: max.
12.11.15 15:28
29

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Swiss perfection 443

Table des Matières