Selecting A Location; Visual Check - BOND MANUFACTURING HYFP50095-1 Manuel Du Propriétaire

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

LP (Liquid Propane) gas supply connection
Always confirm that the burner control knob is in the OFF position before connecting the gas supply.
Do not obstruct the flow of combustion air and ventilation air to the appliance.
To Connect:
1
Ensure that there is no debris caught in the head of gas cylinder, head of the regulator valve.
2
Insert the nipple of the valve coupling into the cylinder valve and tighten the black coupling nut
by turning it clockwise with one hand while holding the regulator with the other hand. (See
diagram.) Hand tighten only.
To Disconnect:
1
Always confirm that the cylinder valve is in the OFF position
before disconnecting the gas supply.
2
Hold the regulator with the one hand and loosen the black
coupling nut by turning it counter-clockwise with the other
hand. (See diagram.)
IMPORTANT
Disconnect the propane cylinder from the regulator valve when the appliance is not in use.

SELECTING A LOCATION

Always place this outdoor appliance on a hard, level non-combustible
surface such a concrete, rock or stone.
Minimum Clearance from Unit to Combustible Materials
72"(182.9cm) from the top; 48" (121.9 cm) from all sides and back.
Do not locate this appliance under any overhead enclosure.
Position the appliance so that you have easy access to the control
knob.

VISUAL CHECK

Prior to each use, check the hose and valve for excessive wear or abrasions.
LEAK TEST
1
Perform a leak test in a well ventilated area outside
2
Make sure any open flames or cigarettes are extinguished.
3
Remove the battery.
4
Ensure the burner control knob is in the "OFF" position
5
In a bowl, create a soap solution using 1 part water and 1 part liquid detergent
6
Apply the soapy water solution to all connections.
7
Open LP tank valve.
8
A gas leak will be detected by expanding bubbles originating from the point of the leak
9
If a leak is found at any connection point or if you smell gas, close the tank valve, disconnect the tank and do not use the appliance
until repairs can be made.
8

Publicité

Table des Matières
loading

Table des Matières