Waring Commercial BB300 Série Manuel D'instructions page 7

countdown timer with + and
– buttons. Always use HIGH
speed for crushing ice. The
blender can operate in two
modes: timer mode and
continuous mode.
4. For timer mode, press the ON/
OFF button. Press the + or –
button to set the desired time.
The electronic timer will indicate run time in 1-second
intervals up to a maximum of 99 seconds. After the
desired time is set, press HIGH or LOW to start the
blender. The timer will count down to 0 in 1-second
intervals and blender will shut off. Pressing the PULSE
button or the STOP button will override the timer and
the blender will stop regardless of time left on timer.
5. If the STOP button is pressed, the timer function will
turn off and the unit will return to continuous mode. To
reactivate timer, press + or – button. When using the
electronic timer again, the initial time will be the last
time set. NOTE: If unit has been unplugged, the timer
will default back to 5 seconds.
6. For continuous operation, press either the LOW or
HIGH button when timer is not lit. If the timer is lit and
you want to use continuous mode, press the STOP
button and proceed. When finished blending, press
STOP. For momentary operation, press the PULSE
button. Motor will run on HIGH speed until the button is
released. Blue LED light will blink while in operation.
NOTE: This blender utilizes a Slow Start
beginning HIGH or LOW operation, the unit will start in a
lower speed for 1 second and then switch to the full selected
speed. PULSE utilizes a .5-second Slow Start
for a more even blending of ingredients in jar.
7. Allow motor to come to a complete stop before
removing container from blender base. Never place
feature. When
™
7
. This allows
™