Disposal And Recycling - HERKULES DLS2000 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18

Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material and
can therefore be reused or can be returned to the raw
material system. The unit and its accessories are made
of various types of material, such as metal and plastic.
Defective components must be disposed of as special
waste. Ask your dealer or your local council.
Troubleshooting
Problem
Compressed air device does not
start or lacks power
Tool no longer latches into the tool
receiver or does not lock into place
Tool cannot be inserted or removed
Device operates continuously with-
out the trigger lever being actuated
Possible Cause
Piston jammed (rusted) in the housing
due to a lack of oil
Dirt has penetrated via the air hose
Too much lubricating oil used or water in
the striking mechanism
Pressing force too high
Output power of the air source too low
Tool or tool receiver worn out. (Most
often caused by excessive pressure or
no-load strokes)
Dirt in the sliding sleeve prevents
unlocking
Valve defective
Help
• Press the piston back with a striking bolt
through the tool receiver
• Introduce a little oil into the connection
hose and into the tool receiver
• Run the device briefly without a tool
• Repeat this process a few times
Repair must be carried out by a specialist
workshop
Run the device briefly without a tool
Grease tool receiver and reduce pressing
force
Use an air source with a higher output power
Repair must be carried out by a specialist
workshop
Repair/cleaning must be carried out by a
specialist workshop
Repair must be carried out by a specialist
workshop
17 І 164

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

3909601931

Table des Matières