Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• If you do not use the infrared heater for a long time pull the plug out of the socket or switch off
the unit by means of the pull switch.
• Switch the device off immediately, if safe operation is no longer possible, and safeguard
against unintentional operation.
Safe operation is not possible anymore, if:
• the device has visible damages,
• the device does not work anymore after lengthy unsuitable storage.
7. START-UP
The intended use, the safety notes, and the technical data are to be observed prior to start-up. En-
sure prior to start-up that the radiant heater is suitable for the application, for which it is to be used.
8. ASSEMBLY AND INSTALLATION CONDITIONS
• Before mounting make sure that the radiant heater for the diaper changing table is mounted
on the wall in such a way that it can radiate directly onto the baby.
• The minimum distance of the device to furniture and easily combustible materials such as
stores and curtains must be 70 cm.
• The installation height of the device should be at least 1.80 meters.
1.
Slacken both the screws fitted on the side of the wall bracket so that the wall bracket can be
moved at an angle of approx. 75°.
2.
Now slacken the central screw of the wall bracket and remove the cover.
3.
Hold the infrared heater on the wall to which it is to be fitted. Transfer the two drilled holes,
with a suitable pin, to the wall. Remember that there must be a grounded socket close to
the infrared heater.
4.
Before drilling make sure that there are no power cables or water pipes in the wall to be
drilled, call in an expert if necessary.
5.
Now drill the two holes into the wall with a 5 mm drill and insert two dowels.
6.
Then hold the infrared heater, with its fastening slot, over the dowels and screw the wall
bracket, with the screws and washers supplied, onto the wall. Without the washers the
fastening is not sufficiently secure.
7.
Now that the infrared heater has been rigidly assembled you need only fasten the wall
bracket cover. Press the cover onto the wall
bracket so that you can hear it engage.
8.
Now set the tilting angle you require and retigh-
ten both the side screws.
9.
Finally connect the mains cable to an earthed
plug and socket.
We can accept no claims for damage caused
due to inadequate or incorrect installation of
the unit!
1.
Minimum distance from the ceiling to the unit
2.
Minimum distance from the baby to the unit
3.
Minimum distance from the ground to the unit
12
35 cm
3
1
2
Publicité
Table des Matières
