Description Of The Remote Control - Fanelite FS7423 Notice D'utilisation

Plug in the power cord.
Using the control panel or the remote control (insert the supplied batteries into the rear compartment of the
remote control) :
Power ON/OFF
Press the corresponding button to turn ON/OFF the fan.
Speed
Press the corresponding button to set the speed (6 possible settings). Each time the button is pressed, the
speed increases by one level. The corresponding LED to the selected speed lights up in green on the control
panel.
- Speed 1 : silent mode (low speed)
- Speed 2 : silent mode
- Speed 3 : sleep mode
- Speed 4 : natural mode
- Speed 5 : normal mode
- Speed 6 : normal mode (high speed)
Silent mode : The fan operates at low speed, in order to emit as little noise as possible.
Sleep mode : When you fall asleep, the body temperature decreases gently. This means that you are less
and less in need of the fan as time goes by while you sleep. If you select this mode, the unit will reduce its
speed and reproduce the effect of the natural wind in different ways depending on the selected speed. The
night mode is ideal in case of sensitivity to colds.
Natural mode : The fan reproduces the effect of the wind by operating alternately at different speeds and
intermitences.
Normal mode : The fan operates normally according to the selected speed.
Oscillation
Press the corresponding button to activate or deactivate the oscillation.
Timer
When the fan is in operation, you can set the timer by pressing the corresponding button so that the fan
turns off automatically after the selected time has been reached. 6 possible settings, from 1 hour to 6 hours.
Each time the button is pressed the timer increases by one hour. The corresponding LED to the selected
time flashes green on the control panel.
When the fan is not in use, you can set the timer by pressing the corresponding button to turn ON the unit
automatically after the selected time has been reached. 6 possible settings, from 1 hour to 6 hours. Each
time the button is pressed the timer increases by one hour. The corresponding LED to the selected time
flashes green on the control panel. In this configuration you can set the starting speed using the speed
setting button, the corresponding LED to the selected speed lights up in green on the control panel.

DESCRIPTION OF THE REMOTE CONTROL

1. Button ON/OFF light
2. Timer setting button
3. Speed setting button
4. Button ON/OFF oscillation
5. Button ON/OFF power