AEG SFB48811AS Notice D'utilisation page 27

Problem
Water flows into the refriger-
ator.
Water flows on the floor.
The temperature in the ap-
pliance is too low/too high.
There is too much con-
densed water on the rear
wall of the refrigerator.
There is frost on the rear wall
of the refrigerator.
Door does not open easily.
Possible cause
The water outlet is clogged.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
The food products' tempera-
ture is too high.
Many food products are
stored at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
Door was opened too fre-
quently.
Door was not closed com-
pletely.
Stored food was not wrap-
ped.
The ambient temperature is
high and the appliance is set
to the lowest temperature
The appliance is fully loaded
and is set to the lowest tem-
perature.
You attempted to re-open
the door immediately after
closing.
ENGLISH
Solution
Clean the water outlet.
Make sure that food prod-
ucts do not touch the rear
plate.
Attach the melting water
outlet to the evaporative
tray.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces-
sary.
Open the door only when
necessary.
Make sure the door is closed
completely.
Wrap food in suitable pack-
aging before storing it in the
appliance.
Set the temperature regula-
tor to a higher temperature
to allow automatic defrost-
ing.
Set the temperature regula-
tor to a higher temperature
to allow automatic defrost-
ing.
Wait a few seconds between
closing and re-opening of
the door.
27