Adjusting Mounting Rail Depth; Wall Mounting The Enclosure; Mounting - Tripp-Lite SmartRack SRW10US Guide Du Propriétaire

5. Enclosure Configuration

5.5 Adjusting Mounting Rail Depth

Warning: Do not attempt to adjust rails while equipment is installed in the enclosure. Do not
attempt to use rails without screws installed. (2 per rail.)
The 4 mounting rails are pre-installed to accommodate equipment with a mounting depth of 20.5 inches
(521 mm). Do not adjust the mounting rails unless your equipment requires a different mounting depth.
The front and rear sets of rails can be adjusted independently for mounting of equipment with depths
between 3 inches (76 mm) and 20.5 inches (521 mm).
1 Each rail is connected to the enclosure with 2 screws: 1 in the upper corner and another in the lower
corner. Using a Phillips-head screwdriver, remove the screws that fasten the rails to the enclosure.
2 Slide the mounting rails to the desired depth and reattach them using the screws you removed in
Step 1.

6. Wall Mounting the Enclosure

Warning: Do not attempt to mount the enclosure to the wall with equipment mounted in the enclosure.

6.1 Mounting

There are 16 keyhole cutouts on the back door of the enclosure. Each keyhole can accommodate an M10
or 3/8" bolt. The holes are centered and beginning with the two innermost holes, the centers are 12.625",
14.875", 17.125" and 19.375" apart, respectively moving outward and horizontaly. Holes are then 17.858"
apart vertically, as shown in the diagram.
Using a level, measure to position your mounting areas precisely. Use appropriate fasteners (not included)
to secure the enclosure to the wall. Warning: The hardware you plan to use and the area you plan to
mount the enclosure to must be able to withstand the weight of the enclosure and all mounted
equipment. For the weight of the enclosure and its capacity, see the specifications on page 8.
( continued )
6
1
19.375"
17.125"
14.875"
12.625"
16"
16"
17.858"
16"
16"
2