Endres COSYPOLO Manuel D'installation Et D'utilisation page 5

COSYPOLO PATIO HEATER - Assembly and operating instructions
Infra-red outdoor heater (suitable for 5 kg or 13 kg G30 / G31 gas cylinders
Assembly and operating instructions
These instructions should be kept for possible future use.
Before you commence to use your heater for the first time, please read these operating instructions carefully and observe in
particular the instructions on safety. The materials of the heater and the way it is constructed have been selected in such a way
that functional disruptions / malfunctions are excluded provided the heater is used in the proper manner. In exceptional cases
it can happen that the radius of the door is changed slightly in the course of transport with the result that more force is required
when inserting the door into the gas cylinder housing. In such a case the door can be readjusted or bent without any risk by
manually drawing it out or pressing it together gently so that it can again be inserted easily into the gas cylinder housing.
I. Assembly
Before assembling your heater, please check that all the items listed below are present.
For assembly you will need the following tools:
1 Phillips screwdriver
3 wrenches (SW 8, SW 14 and SW 17)
Item 1 Heat protection plate
Item 2 Burner, complete
Item 3 Cylinder housing half
Item 4 Cylinder housing half
Item 5 Door
Item 6 Foot
Item 7 Phillips screw M6x12 V2A
Item 8 Hexagon nut, M6
Item 9 Serrated lock washer, diameter 6.4
Item 10 Washer, diameter 6.4
Item 11 Edge protection piece
Item 12 Phillips screw, M5x12 V2A
Item 13 Serrated lock washer, diameter 5.3 mm
Item 14 Hexagon nut, M5
1. Fit the edge protection pieces (10) into the handle openings
in the two cylinder housing halves (3 and 4).
2. Mount the two cylinder housing halves (3 and 4) with 4 screws (12),
4 serrated lock washers (13) and 4 hexagon nuts(14) (may be premounted).
3. Mount the cylinder housing halves (3 and 4)
to the foot (6) with
4 screws (7),
4 serrated lock washers (9),
4 washers (10) and
4 hexagon nuts (8).
(detail: Fig. A)
4. Now place the complete burner (2) on the cylinder housing
halves (3 and 4) and secure it with 4 screws (7), 4 serrated
lock washers (9), 4 washers (10) and 4 hexagon nuts (8).
(detail: Fig. B).
Important: Carry out assembly in such a way that the gas fittings
(gas cock with toggle and piezo igniter) are positioned at the
cut-out part of the cylinder housing (detail: Fig. C).
5. Insert the door (4).
6. Place the heat protection plate (1) with the lug on the
burner head (2) (detail: Fig. B).
7. For connecting the heater to the gas cylinder please see section II.
610000070_300005370_300005380_Manual_D_GB_FR_SE_CZ_IT_NL_050109.indd 5
1 piece
1 piece
1 piece 7
1 piece
1 piece
12
8
1 piece
9 13
8 pieces
8 pieces
8 pieces
10 14
8 pieces
2 pieces
11
4 pieces
4 pieces
4 pieces
10
7
1
7
5
B
3/4
A
9 8
10 9 8
Expand your life
GB
1
2
11
5
6
Detail Abb. A
Detail Abb. B
Detail Abb. C
05.01.2009 13:06:53