Part Names And Functions; Main Power Switch - Audio-Technica ATW-DA410 Manuel De L'utilisateur

• When you unplug the power cable, if the plug is dusty or dirty, wipe it off with a soft, dry cloth.
• Do not use anything like benzene or paint thinner to clean the product.
• When storing the product for an extended period, wrap the product in plastic to protect it from dust.
• The wireless system may be affected by electromagnetic noise from automobile spark plugs, light dimmers, computers, OA
devices, or electric musical instruments. Position the components of the system in a place where they are less likely to be affected.
• Only use this product in combination with devices specified by the manufacturer.
• Do not use outside the USA and Canada. Use abroad may be punished according to the laws of the relevant country.
• Use 120 V AC 60 Hz power source. Refer to "Specifications" for product ratings.
(1)
(2) (3)
(1) Power switch
Press the switch to turn the power on.
Press the switch again to turn the power off.
The power switch lights up when the power is turned on.
(2) Antenna power switch
(off when shipped from factory)
By turning the switch on, you supply 12 V DC to ANT A IN or
ANT B IN (antenna input jacks for both channels A and B).
* Power cannot be independently supplied to ANT A IN or ANT B IN.
(3)(5) 1:4 Active splitter section
ANT A IN, ANT B IN:
These are the antenna input jacks for channels A and B. By
turning on the power switch for the antenna, you supply 12
V DC.
OUT 1 to 4:
These are four distribution output jacks for channels A and
B.
Maintenance
Notes on use

Part names and functions

(4) (5)
(4)(6) 1:2 Passive splitter section/2:1
Passive combiner section
These are distribution and combination sections for
channels A and B.
When input to the SUM jack, signals are distributed to and
output from PORT 1 and 2 jacks.
When input to PORT 1 and 2 jacks, signals are combined
and output from the SUM jack.
* The SUM jack and PORT 1 and 2 jacks support DC through currents.
(7) AC IN terminal
Use the IEC-type connector for 120 V AC 60 Hz power input.

(8) Main power switch

Press the main power switch to turn the power on.
Turn the main power switch on before turning the front
panel power switch on.
(6) (7)
• This product is only for use in the USA and Canada. It may not
be used abroad.
Front panel
Rear panel
(8)
2
E
N