Sleep Mode; Overheat Protection - Philips Essence HD2580 Mode D'emploi

ENGLISH
8
3 Press the one-side toasting button
instructions given in the 'Toasting bread' section (fig. 10).
Note: the toasting process cannot be adjusted or monitored when the one-side toasting function is
used.
The LED for one-side toasting blinks slowly two times and then burns continuously until the toasted
bagel or baguette halves pop up.
You have to press the one-side toasting button
4 Push the toasting lever down to switch the appliance on.
Heating up rolls or croissants
1 Activate the warming rack by turning the bunwarmer knob counterclockwise (fig. 11).
Never put the rolls to be warmed directly on top of the toaster without placing the warming
rack to avoid damaging the toaster.
2 Put the rolls or croissants in the centre of the warming rack (fig. 12).
Do not warm more than 2 items at a time.
Ô
3 Push the button and push the toasting lever down
The warming function LED blinks slowly two times and then burns continuously until the toasting
lever pops up to indicate that the rolls or croissants are ready.
Note: If you want to heat the rolls or croissants on both sides, turn them after the toaster has
switched off and turn the toaster on again by pressing the
down.
The warming function must be activated before every new warming cycle.

Sleep mode

If the toaster has not been used for 10 minutes, it will go into sleep mode, which means that
all LEDs will go out.
You can re-activate the toaster by pressing any button.The LED of the last browning level selected
will go on again.
Cleaning
1 Remove the plug from the wall socket.
2 Let the appliance cool down.
3 Clean the toaster with a moist cloth.
Never immerse the appliance in water.
4 Remove crumbs from the appliance by sliding the removable crumb tray out of the toaster
(fig. 13).
Do not hold the appliance upside down and do not shake it to remove the crumbs.

Overheat protection

1 Toaster will switch off when it overheats (at 100cC).
All LEDs on the control panel will go out for 2 seconds, the toasting lever will go up and the toast
will pop up.
The first and fifth LEDs will both blink until a temperature of 60cC has been reached inside the
toaster.

and set the browning level according to the

before every new one-side toasting cycle.
Ô
button and pushing the toasting lever