Replacing The Filter; Troubleshooting Tips - INVENTOR Spring Manuel D'emploi

Replacing the Filter

1. Replacing the filter
Filters are a consumable product and may have different life cycles. It is highly
recommended to replace the filter regularly to achieve the best filtration affects.
2. The filter is not a reusable product. It must be replaced.
3. To avoid using the wrong filter, it is recommended to purchase replacement filters from the
dealer.
4. Please refer to the steps listed in the "Installation Method" of this manual.

Troubleshooting Tips

Before calling for service, review the chart below.
Symptom
The machine
does not run
Poor filtration
effect
If the following occurs, please send for repairs.
1. The above troubleshooting tips have not resolved the issue.
2. Water or objects have entered the unit.
NOTE:
All the illustrations in the manual are for explanatory purposes only. The actual
shape of the unit you purchased may vary.
The design and specifications are subject to change without prior notice.
Contact your local retailer or dealer for details.
Possible Cause
1. The cord is not
plugged in or not
properly inserted.
2. The power switch has
not been turned on.
1. The filter has been
installed incorrectly.
2. It is time to replace the
filter.
3. Objects are blocking
the inlet.
7
Possible Solution
1. Make sure the power
cord is securely and
properly inserted.
2. Press the "ON/OFF"
button on the panel.
1. Make sure the filter is
installed properly.
2. Replace the filter.
3. Remove the objects
blocking the inlet.