Manual Operation; Replacing The Stylus - Audio-Technica AT-LP60-BT Manuel D'installation

Masquer les pouces Voir aussi pour AT-LP60-BT:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Caution: When the tone arm reaches the end of the record, it
will lift and return to the tone arm rest automatically. When this
happens, do not interfere with the tone arm's motion, or
damage to the mechanism may occur.
If the tone arm does not return automatically to the tone arm
rest after the record has finished playing, simply press the STOP
button to complete operation.

Manual Operation

1.
Remove the stylus guard from the stylus assembly (Fig. 4).
2.
Put a record on the turntable. If needed, use the 45 RPM
adapter (Fig. 5).
3.
Select the size of record: 12" or 7" (Fig. 6).
4.
Select the speed: 33
/
1
3
5.
Press the Lift button in to raise the tone arm (Fig. 8c).
6.
Gently move the tone arm so the stylus is over the point on
the record where play is desired to begin.
7.
Press the Lift button again to gently lower the tone arm and
play record.

Replacing the Stylus

While holding the head of the tone arm, rotate the front of the stylus
assembly in a forward and down motion to remove it (Fig. 9). (As
you remove the old assembly, note its position and "feel," to aid in
properly installing the new one.)
Install the new stylus assembly as shown in Figures 10a/10b, being
careful not to touch the actual stylus. Make certain that the projection
at the back of the assembly is fully seated in the cartridge body first
(Fig. 10a), and that the assembly "clicks" up into place, with no gap
between its top edge and the front of the black plastic tone arm head
(Fig. 10b). Replace the stylus after 400 hours of use.
To maintain original performance, insist upon a genuine Audio-Technica
brand replacement stylus. Look for the Audio-Technica trademark (
on the front of the stylus assembly and on the packaging.
RPM or 45 RPM (Fig. 7).
Figure 6
Figure 7
Figure 8
8a
8b
Figure 9 – Removing the stylus
)
Figure 10 – Installing a new stylus
10a
Engage in
body first
10b
Operation (continued)
(Out)
(In)
8c
Button Position:
Out In
Tone Arm Action:
Lower Raise
No gap here
English
7

Publicité

Table des Matières
loading

Table des Matières