Sygonix Verona Notice D'emploi page 3

Operating instructions
GB
LED wall lamp "Verona", 1 x 1 W
Intended use
The wall light is intended for illuminating indoor areas; it only may be installed and
operated in dry, enclosed indoor spaces. The product is intended for installation on
a wall.
The safety instructions must be observed at all times!
Any other use than that described above may damage the product. Moreover, this
may give rise to hazards such as short-circuiting, fi re, electric shock, etc. No part of the
product may be modifi ed or converted!
This product complies with the applicable National and European requirements. All
names of companies and products are the trademarks of the respective owner. All
rights reserved.
Package Contents
• Wall lamp
• Allen key
• Operating Instructions
Explanation of Symbols, Inscriptions
The lightning symbol indicates a health hazard, e.g. electric shock.
This symbol indicates specifi c risks associated with handling, function and
use.
The "arrow" symbol indicates special tips and operating information.
The product is intended to be located and used only in dry indoor spaces;
it must not get damp or wet.
Observe the operating instructions!
Safety Instructions
Read the complete operating manual carefully before using the product,
as it contains important information about the correct installation and
operation.
The warranty will be void in the event of damage caused by
failure to observe these safety instructions! We do not assume any
liability for any consequential damage!
We do not assume any liability for material and personal damage caused
by improper use or non-compliance with the safety instructions! The
warranty will be void in such cases!
Caution!
The product may only be installed by a qualifi ed technician (e.g. electri-
cian) who is familiar with the relevant regulations (e.g. VDE, German
electrical wiring regulations)!
Improper work carried out at the mains voltage endangers not only your
life but also the life of others!
If you do not have the expertise required for the installation, do not in-
stall it yourself but entrust a qualifi ed electrician.
• The unauthorised conversion and/or modifi cation of the product is not
allowed for safety and approval reasons (CE).
• The product is not a toy and must be kept out of the reach of children! There
is a risk of a lethal electric shock!
• The product may be operated only on the mains voltage (see section "Tech-
nical Data"). Never try to operate the product at another voltage, as this will
cause its destruction.
The home technology brand for the entire house. More information at www.sygonix.com
• The product is constructed for protection class I; the earth cable must be
connected.
If there is not a mains supply with a protective earth wire available at the
place of installation, the product must not be connected/used there. In this
case, install a new voltage supply with a protective earth wire.
• The product may not be operated on a dimmer.
• This product is only to be installed and used in dry conditions indoors. The
product must not get damp or wet as this may damage it; danger of a fatal
electric shock!
• Do not use this lamp in spaces or under adverse ambient conditions where
combustible gases, vapours or dust are or may be present! There is a risk of
explosion!
• Do not hang or attach objects (e.g. decorative material) to the wall light,
there is a risk of fi re!
• Attention, LED light:
Do not look directly into the LED light!
Do not look into the beam directly or with optical instruments!
• The product must not be exposed to extreme temperatures, strong vibra-
tions or heavy mechanical stress.
• If you have reason to assume that safe operation is no longer possible, dis-
connect the product immediately and secure it against inadvertent opera-
tion. After this, let an expert check the product.
It can be assumed that safe operation is no longer possible if:
- the product shows visible signs of damage,
- the product does not work at all or works poorly (fl ickering light, leaking
smoke or a smell of burning, the light fl ickers, audible cracking noises, dis-
colouration to the product or the adjacent surfaces.)
- the product was stored under unfavourable conditions
- it was exposed to heavy loads during transport
• Do not leave packaging material carelessly lying around since it could be-
come a dangerous plaything for children.
• In commercial institutions, the accident prevention regulations of the Em-
ployer's Liability Insurance Association for Electrical Systems and Operating
Facilities are to be observed!
• If you have any questions that are not answered in this manual, please con-
tact our technical service or another specialist.
Preparations for Installation
Pay attention to the chapter "Safety Instructions"!
• Only install the wall lamp on a stable surface. Use screws and plugs that are suitable
for the surface. Only use the product when it is fi rmly mounted/steady.
• The wall lamp must be installed and used out of the reach of children.
• The wall lamp must be protected on the user's distribution board by a 10/16A fuse. A
earth circuit fault interrupter must be installed before this (FI protective switch).
• The wall lamp must be voltage-free during installation. It is not suffi cient to just turn
off at the light switch!
Turn the power off and ensure that none of the poles is carrying a current by remov-
ing the electric circuit's fuse, or switching off at the circuit breaker. Secure it against
unauthorised reconnection, e.g., with a danger sign. In addition, switch off the
associated ground fault circuit interrupter (breaker).
• Check that the mains cable is free of current e.g. with an appropriate tester.