Content
Camera
Velcro-pad
ATTENTION!
Through a collision at a high speed, the record can be deleted.
ATTENTION!
The privacy of others is protected by law and should be taboo. The recording of third party can be a illegal act. You are responsible for
your acting.
Please Note:
Take the CarCamOne out of the car if the outside temperatures are extremely low or high. Avoid direct sunlight when
leaving the car. The internal batteries can stand temperatures from -10°C to +80°C (14°F – 176°F)
Prepare for first run
Connect the camera to your PC with the USB-cable to charge the camera before using the first time. Keep the "ON/CAR-switch" at
"CAR". The display activates after some seconds. The charging will take 3 hours minimum.
The camera's battery will only be charged when the cars generator runs. This is not recommended for first time preparation.
Charging the Camera with 12V AC/DC Adaptor is not possible!
Insert a SD-card (max. 8GB) with 4MB/sec writing speed. Use a pen to get the card in deeply to „click"!
Mount the CarCamOne to the Baseplate
Fix the base plate – at the car's dash board for example - and slide in the camera. Keep the switch at "CAR"-Position!
Make sure of the cams direction. Wrong polarity may damage the camera.
Eyelet band
USB-Cable
12V/24V Cigarette Plug Adaptor with Baseplate