Inserting - VWR Zippette Pro Manuel D'instructions

Inserting the return spring (when applicable)
To insert the return self-priming spring follow the steps below:
1. Make sure that the Zippette Pro is completely empty. For ease of operation, assemble the Zippette Pro onto
an empty reservoir bottle and turn the dispense anti-drip tap to 'Open' position.
2. Turn the volume adjustment knob, to set the Zippette Pro to the max dispense volume of 30 ml (Drawing 1).
3. Turn the fixing ring which is located at the bottom of the Zippette Pro's piston sleeve until its raised rib is
aligned with the front piston sleeve slot and remove by gently pulling down (Drawing 1). The fixing ring
should stay on the barrel protection inner sleeve (Drawing 2).
4. Press the two fixing levers on the back of the piston sleeve inwards (Drawing 2), and lever the back piston
sleeve away from the front sleeve assembly (Drawing 3).
5. Remove the front sleeve assembly from the piston locator and move the piston out of its glass barrel
(Drawing 3 & 4).
6. Carefully guide the piston through the spring, and locate the piston back into its glass barrel (Drawing 5).
7. Reassemble the front Zippette Pro piston sleeve (Drawing 5) making sure that the cursor locates under the
stop ring (Drawing 5).
8. Refit the back piston sleeve and pull up the fixing ring (Drawing 6) – turn it half circle to locate it onto the
Zippette Pro piston sleeve (Drawing 7). The unit is now ready for use (see operating instructions page 7).
Drawing 1
Cursor
Raised rib
Threaded
platform ring
Drawing 2
Volume
adjustment
knob
Front sleeve
Back sleeve
Fixing ring
Threaded platform ring
Threaded platform base
|
EN INSTRUCTION MANUAL
Fixing levers
Back sleeve
Barrel protection
sleeve
5
|
VWR