Safety Information; Package Contents; Installation; Restrictions Of Use - VWR Zippette Pro Manuel D'instructions

ZIPPETTE PRO

Safety information

When using the instrument, take into consideration the chemical compatibility of the materials in
•
contact with the liquid
Never leave the Zippette Pro on your work bench with the piston barrel full of liquid without securing
•
the dispense anti-drip tap into 'Closed' position
Always check that the dispense anti-drip tap is in the 'Open' position before attempting to dispense
•
Before adjusting volume always place receiving vessel under nozzle and open tap
•
Never use force
•
Use only original spare parts and original accessories (See pages 14-15).
•
If in doubt, consult your safety officer
•

Package contents

The Zippette Pro kit comprises:
Zippette Pro dispenser
•
Adaptors:
•
38 mm, 40 mm and 45 mm
PTFE inlet tube
•
Return spring
•

Before using the Zippette Pro

Check that the instrument has not been damaged in transit.

Assembly

The Zippette Pro is packed with the dispense nozzle attached and the inlet feed tube removed. The 300 mm
length of PTFE inlet tube provided should be trimmed to fit your particular reservoir. The bottom end should
be cut diagonally at a length that is close to the bottom of the container when the Zippette Pro is assembled
to the container. Longer lengths of inlet tube are available on request.
The threaded platform base of the Zippette Pro has a 30 mm screw thread for use with the recommended
accessories displayed on page 14. The assembled Zippette Pro is screwed to the reservoir using gentle hand
torque applied to the Zippette Pro's threaded platform base only. Removal should also be by means of hand
torque applied to this same base.
Do not operate the piston until the unit is safely and fully mounted on the reservoir bottle.
4
|
VWR INSTRUCTION MANUAL

Installation

Restrictions of Use

NEVER use the Zippette Pro with:
Liquids which are not compatible with PTFE, PVDF, FEP, borosilicate
•
glass, alumina ceramic or those which might attack platinum-iridium
Hydrofluoric acid
•
Liquids which contain solid particles
•
Temperature limits of Zippette Pro and reagent are +15 °C to +40 °C
•
|
EN