Module Programming; Programming Mode; Users Management - golmar Stadio Plus T4502SEML Manuel D'installation

MODULE PROGRAMMING

Check that the proximity reader is switched on and in operation
mode. This status is shown while the lower dot of the display
is blinking, as in the picture.
To enter into programming mode, a three digits PIN code will be
required (factory default 000).
To exit from the programming mode, press "V" button twice or
wait 15 sec. from the last operation.
Press "V" button during 2 seconds.
V
Press arrow "UP" button till the first PIN digit will appears
Press arrow "DOWN" button to move to the next digit.
Press arrow "UP" button till the second PIN digit will
Press arrow "DOWN" button to move to the next digit.
Press arrow "UP" button till the last PIN digit will appears
To validate the code, press "V" button during 2 seconds:
V
P
rogramming mode.
The left digit display will show number 0.
on the display.
The left display will turn off and the center display
will show number 0.
appears on the display.
The center display will turn off and the right display
will show number 0.
on the display.
the display will show the complete code.
In case of valid code, the display will show the first
memory position.
In case of wrong code, the display will show
the message "E–5" and will automatically exit
from the programming mode.
29 30
U
sers management.
IMPORTANT: this module is to be used with ISO cards or key holders
V
To exit from the programming mode, press "V" button twice or wait 15 sec.
from the last operation.
MODULE PROGRAMMING
supplied by Golmar. Other proximity items will be not accepted
even if they have the same appearance.
Once a valid PIN code has been introduced, the
display will show the 1st memory position.
Use "UP" and "DOWN" arrows to select the
desired position, from 1 to 600.
Several cards or key holders can be recorded in one
memory position. Remember that the maximum
number of cards or key holders (users) is 600.
When the display shows the desired memory position,
approach the card or key holder to be recorded.
The display will shows the number of cards
recorded in this position (including the one you are
recording). This number will be shown with a dot
on its right bottom part. The display will show the
selected memory position again.
If you are trying to record an already existing card,
the display will show the memory position where
recorded, coming back to the position you are
trying to record it.
Repeat the above steps to record the rest of cards.
To erase existing cards from a specified memory position,
use "UP" and "DOWN" arrows till the display shows
the desired position. Press "V" button during 2 seconds:
the display will show the number of cards recorded
in this position and will confirm the progress by
showing the message – – –.
To erase all the existing cards, press "V" button during
10 seconds aproximately: the display will show the
message "FdI" once the memory is empty, and the
reader module will exit from programming mode.