Kimex 015-1324 Mode D'emploi page 7

Step 1C
Self Drilled Grommet Hole Installation
1. Position the 48mm Pipe (a) on the mounting surface
and mark the center hole. Remove the tube support. Drill
a 3/8" (10mm) diameter hole at the marked position
through the mounting surface.
2. Stick the EVA Pad (q) on the round surface of 48mm
Pipe (a), see Figure 5.
3. Position the 48mm Pipe (a) on the mounting surface
and secure using the Grommet plate (m), M10 Washer (n),
Spring Washer (o) and M10 Bolt (l). Fasten the M10 Bolt by
provided Wrench (r), see Figure 6.
4. Install the Decorative Cover (s).
Figure 5
Step 2
Install Arm to the Tube Support
Install arm to the tube support, please make sure the wire clip in
the downside. Fasten the bolt by screw driver.
a
q
b
Figure 6
4
a
s
m
n
o
l
h