Kimex 015-1324 Mode D'emploi page 6

Step 1A
C-clamp Installation
1. Install the C-clamp Brace (c2) to the 48mm Pipe (a) using 3pcs C-clamp Brace Bolts (p), see
Figure 1.
2. Install the C-clamp (c1) to the 48mm Pipe assembly according to the thickness of the desk-
top. The thickness can be changed in three positions. Connect it using 2pcs M10x15 Bolts (i),
and tighten using the Allen Key (j). Tighten the C-clamp to the desktop using the 2pcs eye
bolts, see Figure 2.
3. Install the Decorative Cover (s).
a
p
Figure 1
c2
Step 1B
Existing Grommet Hole Installation
If the existing grommet hole comes with a plastic protector,
remove it to ensure a at surface before installing the desk
mount.
1. Stick the EVA Pad (q) on the round surface of 48mm Pipe
(a), see Figure 3
2. Position the 48mm Pipe (a) on the mounting surface and
secure using the Grommet plate (m), M10 Washer (n), Spring
Washer (o) and M10 Bolt (l). Fasten the M10 Bolt by provided
Wrench (r), see Figure 4.
3. Install the Decorative Cover (s).
Figure 3
a
q
c1
a
Figure 4
3
Figure 2
s
j
eye bolt
s
m
n
o
l
i