Kalorik CMM 39732 Mode D'emploi page 7

Fax +32 2 359 95 50
HOW TO USE WITH THE WHISK ATTACHEMENT
Make sure the motor block is disconnected from the power
•
outlet.
Insert the stainless steel whisk (8) gently on its base (7), until you
•
hear a click sound, indicating that the whisk is securely inserted.
Screw the whisk assembly (7) + (8) onto the screw thread at the
•
bottom of the motor unit. For this, hold the motor block and turn
the whisk assembly counter clockwise until it locks in. Gentle
pressure by hand will ensure that the whisk assembly is fully
tightened on to the motor unit.
Put the ingredients into a suitable container such as a tall mixing
•
bowl, cooking pan or mixing cup. Do not overfill, to avoid
splashing when the motor is switched on.
Plug the appliance into a wall outlet.
•
Put the whisk vertically into the ingredients before pressing one of
•
the switches. This will prevent splashing when the motor is
switched on.
Switch on motor by choosing "Speed I" or "Speed II" and blend,
•
but remember to use for no longer than 1 minute of continuous
motor use. The motor must then be rested for 10 minutes.
CLEANING
Caution: Always unplug the unit before cleaning.
•
The motor unit should only be wiped down with a moist cloth.
•
Unscrew the shaft, or the whisk assembly, from the screw thread
•
at the bottom of the motor unit, by holding the motor block and
gently turning the shaft clockwise to dis-assemble it.
Wash the shaft under running water immediately after use. If it is
•
very dirty, it can be washed in warm soapy water.
Dry the detachable shaft thoroughly after washing.
•
The mixing cup, the chopper bowl, the chopper blade and the
•
stainless steel whisk (without its base) are dishwasher safe, or can
be cleaned in warm soapy water.
The chopper lid (5) and the whisk base (7) may be rinsed under
•
the tap, but do not immerse in water.
NEVER IMMERSE THE MOTOR UNIT IN WATER OR ANY LIQUID!
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity. Print only what is inside the frame.
7
Assembly page 7/32
CMM 39732 - 120501