Samsung NX58M9960P Série Manuel D'installation page 23

To check if the bracket is installed and engaged properly, remove the kick panel
and look underneath the range to see that the leveling leg is engaged in the
bracket. Carefully tip the range forward. The bracket should stop the range within
4 inches (10.2 cm) of tipping. If it does not, the bracket must be reinstalled.
If the range is pulled from the wall for any reason, always repeat this procedure
to verify the range is properly secured by the anti-tip bracket. Never completely
remove the leveling legs or the range will not be secured to the anti-tip device
properly.
Step 5. Plug in and place
WARNING
• BEFORE OPERATING OR TESTING, follow the grounding requirements on pages
17–18 in this manual. Improper connection of the grounding plug can result in
a risk of electric shock.
• All gas ranges come with a power cord. The power cord is connected to the
rear of the range. Please review "Electrical requirements" on pages 17–18.
All U.S. and Canadian models are produced with a 3-wire, 120-volt, 60-Hertz
•
electrical system. The entire system, including the power cord, is preinstalled
and prewired at the factory. Altering any part of this system may result in a
short or overload.
Gas Range Plug
Install_NX58M9960PS_DG68-01009A-01_EN+MES+CFR.indb 23
1. Plug in the power cord. Make sure the
outlet meets local or national electrical
codes as referenced on pages 17–18.
2. Slide the range into place.
Check the gas supply line to make sure
3.
it did not get damaged and it stayed
connected during positioning.
4. Check to make sure the back leg of the
range has slid into the anti-tip bracket.
to
Carefully tip the range forward
ensure that the anti-tip bracket engages
the back brace and prevents tip-over.
Step 6. Level the range
1.
2.
Leveling leg
NOTE
• Adjusting the two front legs is usually sufficient, but all four legs adjust if
necessary.
• Adjust the leveling legs only as far as necessary to level the range. Extending
the leveling legs more than necessary or removing legs can cause the range to
be unstable.
3.
4.
5.
6.
7.
Make sure the range is positioned
where you want it.
Using a wrench, level the range by
turning the front leveling legs in or
out as necessary. Counterclockwise
shortens the leg and lowers the range.
Clockwise lengthens the leg and raises
the range.
If range is next to or between cabinets,
make sure the cooktop (without the
surface burner grates) is level with the
countertops.
Position an oven rack in the center rack
position.
Check the level of the range with a
carpenter level using the two positions
shown at right.
After the range becomes level, slide the
range away from the wall so that the
anti-tip bracket can be installed.
After installing and leveling the range,
install Front Leg Covers (right and left).
English 23
2017-12-14 2:40:01