Baumatic F60.2 Mode D'emploi page 16

TROUBLESHOOTING
Defect
Light shines but the
motor does not work
Light does not shine
and the motor does
not work
Grease is leaking
Vibration
Unsatisfactory
suction
The device is leaning
Cause
Blocked ventilator
Defective condenser
Motor bearings are defective
Inner motor winding is burnt,
or the motor smells badly
In addition to the above listed, check the following:
Damaged light
The supply cable is loosen
One-way valve and input
in the ventilation system
are not closed perfectly
Leak from the connecting
point between the U-part
and the cover
Ventilator is defective and
causes vibration
Motor is not installed
properly
The body of the cooker
hood is not installed
properly
The distance between the
body and the cooker is too
big
Too intensive air flow form
open doors or windows
Suspension bolts are not
tightened
Suspension bolts are not
tightened
15
Solution
Release the blockage
Replace the
condenser
Replace the motor
Replace the motor
Replace the light
Connect it (follow the
wiring diagram)
Remove the one-way
valve and tighten with
putty
Remove the U-part and
seal with soap or paint
Replace the ventilator
Tighten the motor
Tighten the body of the
cooker hood
Adjust the distance
Choose another place
and get the device
closer
Tighten the suspension
bolts and bring the
device in horizontal
position
Tighten the suspension
bolts and bring the
device in horizontal
position