Clatronic ProfiCook EKI 3157 Mode D'emploi page 56

ProfiC_BDA_IKP_3157_ka3.qxd
TIMER enter disconnecting time
GB
The cooking functions can be limited in time.
• Press the button FUNCTION (3) and select the setting Timer. The hour digit appears and
begins to flash in the display.
• With the buttons (4/8) you can set now the desired disconnecting time in hours.
• Wait 3 seconds and then the minute digit appears flashing on the display.
• With the buttons (4/8) you can set now the desired disconnecting time in minutes.
• Wait again 3 seconds and then the residual running time and the selected power level
measured in watts appear alternating.
i
NOTE:
- After the timer has been switched on you can change the levels with the buttons
(4/8) at any time.
- Press the button FUNKTION in order to adjust from the cooking function HEATING
to the function WARMING.
- Interrupt: You can interrupt this process at any time by pressing the ON/OFF
button (2).
- The end of the cooking time will be announced in the last minute by an acoustic
signal.
Switching off
• Push the ON/OFF button (2).
• The hob changes back to the standby mode from whatever operating mode. The opera-
tion indicator (1) light goes out.
i
NOTE: The ventilator for the cooling air still continues to run for about 30 seconds.
• Pull the plug.
• Let the device cool down, before you put it away.
Identification of the pot
The device has a pot recognition function. After the pot has been taken from the hob, it
switches back to the standby mode.
In this context, please pay attention to the following:
WARNING:
After use, the hob must be switched off using the provided controls – not over its auto-
matic pot recognition function only!
Hazard of burns!Because of the heat radiated during cooking, dangerously high tempe-
ratures may occur at the cooking zone after the cooking cycle.
56
09.02.2007 9:31 Uhr Seite 56