Installation And Start-Up; Installation - Sibelmed S-BASIC Mode D'emploi

2.5 INSTALLATION AND START-UP

2.5.1 INSTALLATION

To continue with the assembly of the booth, follow the steps shown in the
following chart:
NOTE:
If the door is not assembled for reasons of transportation, or you want to
change the direction it opens in (Fig. 3), take the following steps:
• To change the opening direction, turn the panel 180º.
• To mount the door, place the hinges of the door facing the hinges of the
Panel and insert the pins. Use a hammer to push the pins all the way
through.
• Check the position of the closing wedge and reverse it if necessary.
• Make sure that the door is adjusted and closes properly.
S-BASIC User's manual
Tools for assembly
501-800-MUM · Rev 2.04
EN 8