Technical Specifications - VONROC AG502AC Traduction De La Notice Originale

EN

TECHNICAL SPECIFICATIONS

Model No.
Mains voltage
Mains frequency
Power input
No-load speed
Grinding disc
Diameter:
Bore:
Spindle thread
Weight
Noise and vibration
Sound pressure level L
Acoustic power level L
Vibration
Wear hearing protection.
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN60745; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2 - 3
Fig. A
1. On/off switch
2. Spindle lock button
3. Spindle
4. Guard
5. Main grip
6. Auxiliary grip
8
AG502AC
220-240V~
50 Hz
650 W
12.000/min
125 mm
22.2 mm
M14
1.69 kg
86 dB(A), K=3dB(A)
PA
97 dB(A), K=3dB(A)
WA
2.48 m/s , K=1.5 m/s
2
3. OPERATION
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
Mounting and removing the guard & grinding disc
(fig. B)
Do not use the machine without the guard.
Mounting
• Place the machine on a table with the spindle
(3) facing upwards.
• Keep the spindle lock button (2) pressed and
remove the flange (7) using the flange key (8).
• If necessary, remove the grinding disc (9).
• Remove the flange (10).
• Mount the guard (4). Secure the guard (4) by
2
tightening the screw (11) and the nut (12).
• Mount the flange (10).
• If necessary, mount the grinding disc (9).
• Keep the spindle lock button (2) pressed and
mount the flange (7) using the flange key (8).
Removing
• Place the machine on a table with the spindle
(3) facing upwards.
• Keep the spindle lock button (2) pressed and
remove the flange (7) using the flange key (8).
• If necessary, remove the grinding disc (9).
• Remove the flange (10).
• Remove the guard (4) by loosening the screw
(11) and the nut (12).
• Mount the flange (10).
• If necessary, mount the grinding disc (9).
• Keep the spindle lock button (2) pressed and
mount the flange (7) using the flange key (8).
Mounting and removing the auxiliary grip (fig. C)
Mounting
• Tighten the auxiliary grip (6) into one of the
mounting holes (13).
Removing
• Loosen the auxiliary grip (6) from the mounting
hole (13).
Switching on and off (fig. A)
• To switch on the machine in continuous mode,
slide the on/off switch (1) in the direction of the
grinding disc.
WWW.VONROC.COM