Velleman VM151 Mode D'emploi page 6

Use
USE
1) Using the RGB controller with the supplied RF remote control:
Left button:
Change effect (push until effect changes. Leds blank between each effect)
Effect # Effect description
0 Static red
1 Static green
2 Static blue
3 Static yellow
4 Static cyan
5 Static magenta
6 Static white
7 Hard transition red-green-blue-yellow-cyan-magenta
8 Fade red green blue
9 Running light red green
10 Flame effect (3 independent flames)
11 Hard transition between all 40 colours stored in mem. 1..5
12 Fade between 8 colours stored in memory 1
13 Fade between 8 colours stored in memory 2
14 Fade between 8 colours stored in memory 3
15 Fade between 8 colours stored in memory 4
16 Fade between 8 colours stored in memory 5
17 Random colour fade
6
Adjustable speed
red
blue
Right button: effect speed change
Press and hold button until leds blank. Each press reduces
speed. 8 speed settings are available.
When minimum speed is reached, the unit will jump to max.
speed at the next press
To turn off:
Press and hold both buttons until display blanks. (A brief flash
will confirm the action)
(Current effect and current speed will be stored in memory.
At next power-up, unit will resume)
To turn back on:
Press and hold any key until outputs are turned on again.
To make the unit respond to a transmitter:
Same procedure as turn-off. New transmitter will be stored in
memory.
Unit will no longer respond to previous transmitter.
To make the unit respond to more than one transmitter:
Reset all transmitters to default code.
Make unit respond to this transmitter. All other transmitters that
are set to default code will be able to control the unit.