Sony DSBK-140 Manuel D'installation page 16

Installation
3
16
Take up the slack in the harness by inserting it first into the
cable holder on the left, then into the cable holder on the
right, then again into the cable holder on the left, as shown
in the figure (left and right are as seen from the rear of the
DSR-70/70P).
Place the DV-19 board above the opening where the
battery panel was removed, and connect the harness to the
CN101 on the board.
Cable holders
From connector panel
Notes
• When winding the harness around the cable holders, do
not pull it tight. Loop it loosely through the cable holders
as shown in the figure.
• Make sure that the harness does not pass over or under
any board levers.
To DV-19 board