Group 2 + 3 Fitting Instructions(15-36Kg) - Ickle Bubba Solar Mode D'emploi

GROUP 2+3 FITTING INSTRUCTION (15-36kg)
Securing the child with the Adult Seat Belt (Group 2-3)
Place the car seat against the backrest of the vehicle seat.
Check that the headrest of the vehicle seat does not obstruct
the car seat. If this is the case then adjust or remove the vehicle
headrest. With your child sitting upright and back in the seat,
pull the adult seat belt and pass it across the front of the child.
Pass the lap section of the adult belt over the child' s lap and
under the armrest on both sides of the seat. Ensure the lap belt
is low d own on the child 's lap and firmly engaging with the
pelvis. Fasten the ad ult seat belt connector to the seat belt
buckle (H-2).
Locate the upper portion of the diagonal section of the adult
belt into the d iagonal should er belt guid e located on the top
corner of the back rest (H-1) (8).
Make sure the seat belt is not twisted and remove the slack
(H-3).
Incorrect installation method (H-4).
1. Check the position of the seat belt buckle, ensuring that it is
not being pulled around the child seat onto the red lap belt
guide.
2. Feed the d iagonal section of the vehicle belt through the
upper belt guide on the opposite side to the buckle.
16