Gui Panel Controls Defined - ELAC Integrator Serie Instructions D'utilisation

IS-AMP340 GUI Control Panel (cont)
GUI Controls Defined
The IS-AMP340 amplifier GUI control panel is shown in Figure 6.
Most of the GUI controls are simple and self explanatory, but some of them are described
below in detail.
Power On/Off - Use this control to select the power on/off mode:
• Auto On/Off - The amplifier is detecting the audio signal and it is turning on/off
automatically. If there is no audio for aprox. 20 min. the amplifier is turns off.
• 12V Trigger - Requires 12V (>5 ... 24V DC) control connected to the amplifier. In this mode
the On/Off commands from IR remote and Ethernet will not work.
• Remote Control - In this mode the amplifier can be controlled via both IR remote and
Ethernet.
Volume Settings - Use this control to set the default master volume for selected input.
Input Default Volume - Will set the desired default volume for each input.
System Settings - Use these controls to set the amplifier according to your audio speaker
system.
Do you have a subwoofer [Check Box] - Select this option if you have a subwoofer. If the
audio signal is
Dolby Digital
Do you have a center channel [Check Box] - Select this option if you have a center speaker.
Use center with stereo source [Check Box] - This option will mix the left and right audio signals
and send it to the center speaker in addition to regular stereo audio signal in left and right
speakers, respectively.
ELAC IS-AMP340 | www.elac.com | Page 13
® the sub frequencies are sent to the subwoofer.