AEG PX71-265WT Manuel D'utilisation page 12

12 www.aeg.com
2. Place the window slider kit on the
window. Adjust the length of the
window slider kit according to the
height of window (Fig. 10).
The telescopic rod can be
extended, if the window is
too high.
To do that, first take out the
telescopic rod completely
(Fig.11 A). Then align the 3 hooks
on the extending rod (sold
separately) to the 3 slots on the
end of the telescopic rod and slide
the 3 hooks into the slots, then
press down the extending rod to
lock the slots (Fig.11 B). After that
slide the combined telescopic rod
back into the window kit (Fig.11 C).
Fig. 11 A
Fig. 11 B
Fig. 11 C
3. Press back the locking lever to fix
the length of the window slider kit,
then close the window and pinch
the window kit between the window
and the window frame, to secure the
window kit, peel off the protect film
in the back of the tabs of the anchor
and attach on the window frame,
then fasten the strap (Fig. 12).
Fig. 10
4. Cut the decoration film to an
appropriate length and stick
on the extend rod (Fig. 13).
C: Decoration film
Fig. 12
C
Fig. 13