Operation Tips - AEG PX71-265WT Manuel D'utilisation

16 www.aeg.com
7.3 Drainage
During the Heat and dry mode, you need
to connect the drain hose to the drain
outlet in the back of the unit to drain the
condensate from the unit. Otherwise,
the unit may not function normally and
display show "P1".
A. Discharge into a drain that is lower
than the unit.
B. The unit have a pump to drain the
condensate.
Fig. 23
If necessary you can extend the drain
hose by adapting the drain hose adpator
in the end of the drain hose, then use
a 8-9mm hose to extend.(Fig. 24)
Connect a 8-9mm hose here
to extend the draining hose
Fig. 24
During cooling mode, please replace the
rubber stopper to the hose connector to
reach the maximum performance.

7.4 Operation Tips

Now that you have mastered the
operating procedure, here are more
features in your control that you should
become familiar with.
• The "Cool" circuit has an automatic
3 minutes time delayed start if the
unit is turned off and on quickly.
This prevents overheating of the
compressor and possible circuit
breaker tripping. The fan will continue
to run during this time.
• Temperature can be set between
16°C and 32°C.
• The control is capable of displaying
temperature in degrees Fahrenheit or
degrees Celsius. To convert from one
to the other and back, press and hold
the "TEMP" Up ( + ) and Down ( - )
buttons together for 3 seconds.
• There is a 2-Second delay for the
compressor shutting down when
selecting Fan. This is to cover the
possibility of having to roll through
to select another mode.
• After a power outage, the unit will
memorize the last setting and return
the unit to the same setting once
power is restored.
• Indoor operating temperature range
for this product is 16°C to 35°C.
• During normal operation, the unit's
display will show room temperature
but when the room temperature is
over 37°C the display will show "HI".
• After 60 seconds of control inactivity
the display and indicator lights will
turn off. Press any button on the
control panel or remote control
and the display will resume.