EN
Mars II extreme
Ingenious Accessories
– Sturdy 'V' pegs for hard packed and soft ground
– Exped's own cord line tensioners secure tent lines without awkward knots
– Super strong and lightweight Dyneema core guylines are reflective and
pre-mounted and packed in Cord Stuffsacks
– Combined packsack for poles and tent accessories
– Reflective, glow-in-the-dark zipper pulls will not snag and are color coded
for ease of use
– premounted gear loft!
Optional accessories
– Tent footprint
– Snow and Sand anchors
– additional Cord Stuffsacks
– additional V-Pegs
Simple field tested design
A space saving tunnel shape with the strength of a geodesic design for
enhanced aerodynamics. Continuous pole sleeves with reinforced cross points
simplify tent pole handling.
Setup
Unpack: Un-roll the tent fly side up and secure with two pegs at the foo-
1
tend. In strong winds open both door and rear vent to prevent ballooning
and the tent from flying off.
Poles: First feed the parallel poles and then the ridge pole (grey anodized
2
segment first) gently into their corresponding color and number coded
pole sleeves until seated in the opposite sealed end. Then insert the pole
ends into the tension pocket and pull tight.
Tension: Secure with pegs in the corners and vestibule. Tension the
3
pre-mounted guy lines forming a star pattern that radiates from the
tent's center. In high winds use additional pegs and guylines found in the
accessory bag.
Retension: Humidity (dew, fog, rain) cause silicone coated fabrics to
4
stretch and sag. Retension the fly when necessary to prevent contact
with the canopy fabric.
MARS II EXTREME
Designed in Switzerland | Made in China
vers. 01 / 2018
3 / 18