DMM Coron Helmet iD Notice D'utilisation page 6

5. check the correct position of the helmet and
the correct locking of the systems (buckle and
back size adjust system). If the helmet is worn
correctly, it must not move or rock side to side.
The better the helmet adjustment, the higher
the level of safety.
Check before use
Before use, check the state of the shell and
harness system, check the state of the chin
strap and stitching. Check if the size adjustment
system and chin strap buckle work properly.
Changes to o riginal components
The possible change or removal of original
components of the product can limit its safety
features. It is highly recommended that no
equipment to add further components unless
explicitly advised so by the manufacturer in
writing. Apply colours, solvents, glue or sticky
labels only if they comply with the information
provided by the manufacturer.
Warning! The products must
not be exposed to dangerous
conditions and improper treatments.
Avoid contact with corrosive or aggressive
welding, oils, detergents). Avoid exposure to
high temperatures, for instance by leaving the
helmet inside a vehicle exposed to sunlight.
Avoid contact with heat or sparks. Do not sit on
the helmet and do not compress the helmet in
a sack. Avoid contact with sharp objects. Avoid
letting the helmet fall.
Temperature of use
The product (dry state) may be used
permanently in the temperature range of -20°C
to +35°C.
Duration and replacement
The duration of the product depends on the
typology and frequency of use and well as on
external factors. Although not used, the helmet
is subject to ageing due to the intensity of UV
rays and weather conditions.
Normal use
Duration in case of normal and proper use,
without evident wear marks and under optimal
storage conditions: 10 years.
Maximum duration of t he product under
optimal storage conditions and if not
used: 15 years.
Very frequent use
or under extreme conditions
If the product is used under extreme conditions,
very high or very low temperatures, sea water,
or if exposed to frequent blows and shocks
due to the fall of stones/ice and if it presents
many scratches, its safety features could be
reduced even after a brief period of use so that
the product should be replaced. This helmet is
designed to absorb the energy after an impact.
6