Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
USER INSTRUCTIONS
TIMER FUNCTIONS
TIMER FUNCTIONS
NOTE: the timers are only intended as acoustic advisors to recall the attention of the user.
EN
•
Timers have no effect on the heating elements. Cooking zones must always be stopped
manually by touching the corresponding [OFF] key.
There are two versions of the timer function:
1) An independent timer from 1 to 999 minutes: This function is available when no cooking
zone is active. It beeps when the time has run out.
2) A zone timer from 1 to 999 minutes for each cooking zone: it beeps when the time has run
out. The cooking zones can be programmed independently (the symbol may be less bright if
another cooking zone timer has a remaining time that is less than that set on the independent
timer).
There's a zone timer indicator (13) in each zone display. The timer with the least time is
highlighted and its icon is brighter (13). The other timers are still active and running, but
those timer icons (13) will be less bright.
INDEPENDENT TIMER
INDEPENDENT TIMER
The independent timer is available when none of the cooking zones are active. To activate the
timer, touch the
The time setting (0-999 min) can be changed in increments of one minute with the
to 999.
Holding down the
If the
(or
+ +
The timer can be set by either continuously touching the
(with beeps).
After the timer is set, it begins to count down. The completion of the time is signaled by a beep
or by the flashing of the timer display, which will show "000". To stop the flash and beep, press
the
and
+ +
TURNING OFF/CHANGING THE TIMER
TURNING OFF/CHANGING THE TIMER
The timer can be changed or turned off at any time by turning on the touch display again, if no
cooking zone is on, and touching the
time using the
time is accepted and the timer starts from the new value.
To turn the timer off, touch the
The independent timer remains active even when the main Power key is touched.
16
©2020 Hestan Commercial Corporation
and
keys. The display will show "000", and you can set a time using the
+ +
− −
or
key increases the rate of change up to a maximum value, without beeps.
+ +
− −
) key is released, the rate of increase (decrease) starts again from the initial value.
− −
keys.
− −
and
keys. After adjusting, the "min" icon will flash for a few seconds, then the
+ +
− −
key.
− −
(CONTINUED
or
+ +
and
keys simultaneously to select the timer. Adjust the
+ +
− −
key from 0
+ +
keys or by touching successively
− −
key.
+ +
Publicité
Chapitres
Table des Matières
Dépannage
