Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CONTENTS
1.
Read these instructions.
2.
Keep these instructions.
3.
Heed all warnings.
4.
Follow all instructions.
5.
Do not use this apparatus near water. Do not expose this apparatus to dripping or splahing and ensure that no objects
filled with liquids, such as vases, are placed on this apparatus.
6.
Clean only with a dry cloth.
7.
Do not block any of the ventilation openings. Install in accordance with the anufactures instructions.
8.
Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers)
that produce heat.
9.
Only use attachments/accessories specified by the manufacturer.
10.
Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any
way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus,
the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped
11.
To completely disconnect mains power from this apparatus, the power supply cord must be
unplugged.
Management of WEEE (waste electrical and electronic equipment) (applicable in Member States of the European
Union and other European countries with individual national policies on the management of WEEE) The symbol on
the product or on its packaging indicates that this product may not be treated as regular household waste, but has to
be disposed through returning it at a Telex dealer.
CAUTION:
These servicing instructions are for use by qualified personnel only. To reduce the risk of electric
shock, do not perform any servicing other than that contained in the Operating Instructions unless
you are qualified to do so. Refer all servicing to qualified service personnel.
1.
Security regulations as stated in the EN 60065 (VDE 0860 / IEC 65) and the CSA E65 - 94 have to be obeyed when
servicing the appliance.
2.
Use of a mains separator transformer is mandatory during maintenance while the appliance is opened, needs to be
operated and is connected to the mains.
3.
Switch off the power before retrofitting any extensions, changing the mains voltage or the output voltage.
4.
The minimum distance between parts carrying mains voltage and any accessible metal piece (metal enclosure),
respectively between the mains poles has to be 3 mm and needs to be minded at all times. The minimum distance
between parts carrying mains voltage and any switches or breakers that are not connected to the mains (secondary
parts) has to be 6 mm and needs to be minded at all times.
5.
Replacing special components that are marked in the circuit diagram using the security symbol (Note) is only
permissible when using original parts.
6.
Altering the circuitry without prior consent or advice is not legitimate.
7.
Any work security regulations that are applicable at the location where the appliance is being serviced have to be
strictly obeyed. This applies also to any regulations about the work place itself.
8.
All instructions concerning the handling of MOS - circuits have to be observed.
NOTE:
INTRODUCTION
FRONT PANEL
REAR PANEL
INSTALLATION INSTRUCTIONS
SETTING INSTRUCTIONS
SPECIFICATIONS
BLOCK DIAGRAM
DIMENSIONS
IMPORTANT SAFETY INSTRUCTIONS
IMPORTANT SERVICE INSTRUCTIONS
SAFETY COMPONENT ( MUST BE REPLACED BY ORIGINAL PART )
13
14
17
19
20
21
32
33
The lightning flash with arrowhead symbol, within an
equilateral triangle is intended to alert the user to the
presence of uninsulated „dangerous voltage" within the
product's enclosure that may be of sufficient magnitude to
constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operating and maintance (servicing) instructions in the
literature accompanying the appliance.
12
Publicité
Table des Matières
