Ozone Oxygen2 Manuel D'utilisation page 11

Important: Always complete at least one practice reserve
deployment from a static hang point to ensure that the
system operates smoothly.
5.On leaf no.1 thread a piece of line
through the small loop.
6.Neatly thread this line through the
eyelets of each clover leaf in numerical
order.
7.Fasten by placing the reserve pin
through the loop. Always remember to
completely remove the assisting line,
otherwise the reserve system will not
deploy.
8.Secure handle to the Velcro on the
side of the harness, ensure that there
are no parts of the inner deployment
bag pertruding from the clover leaves.
CONNECTING TO THE PARAGLIDER
Important: Do not attempt to attach the karabiners in any
other position.
TOWING
The Oxygen2 is suitable for towing. The tow release should be
connected to the main karabiners. If in doubt ask a qualified tow-
ing instructor or see operating instructions supplied with your tow
release.
9
The Oxygen2 harness can only be
attached to the risers of your
paraglider via suitably fitting
karabiners using the main hang
points.