Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Tool Tray
Caster Frame
Figure 2 - Assembling tool tray and casters
2. Attach two creeper Side Frames to Caster Frame
with two M8 x 60 Hex Head Bolts, two washers and
two corn nuts each (Fig 2).
M6 X12
Hex Head
Screw
Warning
Plate
M6 X 16
Phillips Head
Screws
Figure 3 - Attaching Creeper Seat
3. Attach creeper Seat Cushion to creeper Side
Frames using two M6 x 40 Phillips Head Screws,
with washers, and nuts, and two M6 x 16 Phillips
Head Screws. Then attach the Warning Plate with
four M6 x 12 Hex Head Bolts as in Fig. 3.
Side Frame
M6 X 40
Hex Head
Screw
WARNING
!
• Read, understand, and follow all instructions
before using this device.
• Never use a creeper/step stool that is damaged.
• Clean any mud, grease, oil or slippery liquids
before using creeper/step stool.
• Do not exceed rated capacity. Rated capacity
is 350 lbs. as a seat, and 400 lbs. as a stool.
(includes user, tools, and equipment).
• Sit down gently. Avoid shock loads caused by
jumping or falling on seat.
• Do not stand on seat.
• When used as a step stool, device must be on
firm, level surface with all four legs contacting
ground.
• Make sure step stool is appropriate height for
intended purpose. Do not overreach.
• Only one person shall use step stool at a time.
• Keep out of the reach of children. This device is
not appropriate for children's use.
• Use on smooth, level surfaces only.
Figure 4 - Attaching Step to Side Frames
4. Fasten Creeper Step to Side Frames using four
M6 x 16 Phillips Head Screws (Fig. 4), ensure that
the Support Brackets are installed between the
Creeper Step and Side Frames.
3
Creeper Step
Publicité
Table des Matières
