Oase FILTOCLEAR 800 Mode D'emploi page 12

12
Connection at water inlet
Push the union nut onto the black spiral stepped hose adapter.
Push / twist the hose on and secure with a hose clip.
Insert the flat seal into the union nut and screw tight onto the
water inlet nozzle:
Connection to water outlet
Push the union nut onto the transparent spiral stepped hose
adapter. Push / twist the hose on and secure with a hose clip.
Insert the green flow vane into the union nut and screw tight onto
the water outlet nozzle.
Note: We recommend diverting the cleaned water via a small
watercourse, for example, instead of feeding it directly back into
the pond. This enriches the water with additional oxygen.
Connecting to cleaning connection
You can have a drainage hose permanently connected to the
cleaning connection. This allows you to drain the dirty water
directly into the sewerage system or onto a flower bed.
Important!: When the Filtoclear is being used in 'filter' mode,
the cleaning connection or any drainage hose connected to it
must always be sealed with the sealing cap and inserted flat seal
in order to prevent the pond from emptying. At the same time the
sealing cap acts as a safeguard in case the function switch is
accidentally set to 'Clean'.
To connect the drainage hose, push the union nut onto the
transparent spiral stepped hose adapter. Push / twist the hose
on and secure with a hose clip. Insert the green flow vane into the
union nut and screw tight onto cleaning connection. In order to be
able to seal the open end of the drainage hose with the sealing
cap, you need to push / twist the black spiral stepped hose adapter
with thread onto the hose and secure it with a hose clip. Screw
the sealing cap and inserted flat seal on tight.
English