Worx WX22AG Mode D'emploi page 12

Using Lock-off & lock-on
switch
If you wish to use the tool
continuously, push the
safety switch lever (B)
forward and depress on/off
switch (A) fully, then push
the safety switch lever (B)
forward again and release
the On/Off switch. Now
your switch has been
locked on for continuously
use. To switch off your
tool, simply depress
On/Off switch fully, the
safety On/Off switch will
automatically release.
Soft Start
Internal electronic
components allow the
motor speed to increase
slowly, which reduces
the"twisting"effect on
your wrists due to the high
12
power motor.
Cutting
Brush Wear Indicator
(WX22AG /WX23AG/
WX23AG.2)
Auto-Stop Carbon Brush
(Only For WX23AG.1)
Replacing The Carbon
Brush
Rough Grinding
WARNING! Never
use a cutting disc for
roughing.
WORKING HINTS FOR YOUR
ANGLE GRINDER
1. Always start at no load to achieve
maximum speed then start working.
2. Do not force the disc to work faster,
reducing the Disc's moving speed means
longer working time.
3. Always work with a 15-30 angle between
Angle Grinder
4. When using a cutting disc never change the
See Fig. G
5. When cutting very hard material best
6. When using a diamond disc it will become
7 . Always ensure the workpiece is firmly held
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
See Fig. H
maintenance.
Your power tool requires no additional
See Fig. I
lubrication or maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
See Fig. J
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
See Fig.K
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal and will not
damage your power tool.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard.
disc and workpiece. Larger angles will
cut ridges into the workpiece and affect
the surface finish. Move the angle grinder
across and back and forth over the
workpiece.
cutting angle otherwise you will stall the
disc and angle grinder motor or break the
disc. When cutting, only cut in the opposite
direction to the disc rotation. If you cut in
the same direction as the disc rotation the
disc may push itself out of the cut slot.
results can be achieved with a diamond
disc.
very hot. If this happens you will see a full
ring of sparks around the rotating disc.
Stop cutting and allow to cool at no load
speed for 2-3 minutes.
or clamped to prevent movement.
EN