Klarstein 10034558 Mode D'emploi page 12

EN
12
OPERATION
1. Place the appliance on a uniformly dry, heat-resistant, non-slip surface as close as
possible to the wall outlet.
2. Open the lid and fill the hot water dispenser with water. The water level must not
exceed the MAX mark on the container. Do not place the hot water dispenser
directly under the tap for filling. Use a kettle or other vessel with a spout for filling.
3. Press the lid down until it clicks into place.
4. Connect the hot water dispenser to the power supply. The BOILING indicator will
illuminate.
5. After the water has been boiled, the hot water dispenser switches off and the
BOILING indicator goes out. The hot water dispenser now automatically monitors
the water temperature.
6. As soon as the water temperature drops, the hot water dispenser automatically
switches on again to keep the water warm. The corresponding KEEP WARM
indicator will illuminate.
7. To pour water into a cup, press the water dispenser button (B). The machine is
equipped with an additional water dispenser button (J) located behind the tap.
Press the cup against this button to fill the cup with water.
8. If you want to boil the water again, press the REBOIL button (D).
9. When hot water is no longer needed, unplug the appliance from the wall socket.
Note: Do not empty the hot water dispenser completely. When the water level
reaches the minimum mark on the scale, unplug the appliance from the wall outlet
and wait for the appliance to cool down. Then top up with water. Never open the lid
while the appliance is boiling or immediately afterwards.