Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
To Convert Gas Pressure Regulator
1. Remove oven racks from inside the oven cavity.
2. Remove the storage drawer. See "Replace Oven Racks and
Storage Drawer" section.
3. Remove the oven door. See "Oven Door" section in the Use
and Care Guide for oven door removal instructions.
4. Using a Phillips screwdriver, remove the 2 oven bake burner
cover screws located at the rear of the oven.
A
A. Oven bake burner cover
B. Oven bake burner cover screws
5. Lift up and remove oven bake burner cover.
6. Remove the 2 oven bake burner screws and set aside.
7. Swing the oven bake burner to the side and lift it off the oven
orifice and set aside.
A
A. Oven bake burner screws
B. Oven orifice
8. Locate the access panel at the rear of the storage drawer
compartment. Using a ¼" (6 mm) nut driver, unscrew the
2 access panel screws. Remove access panel and set aside
along with the 2 screws.
A. Access panel screws
B
B
A
A
9. Locate gas pressure regulator at the rear of the storage
drawer compartment.
IMPORTANT: Do not remove the gas pressure regulator.
10. Unscrew the regulator cap and remove the plastic cover.
A. Plastic cover
B. Regulator cap
11. Flip the regulator cap over and replace the plastic cover.
A
A. LP gas position
B. Natural gas position
C. Plastic cover
12. Screw the regulator cap securely back into place. Do not
overtighten.
2
A
B
B
C
15
Publicité
Table des Matières
