Installation And Connection; Remedy Of Faults - aquanique UA 1200 LED Notice D'emploi

- EN -

Installation and connection

W A R N I N G
Electrical current may cause death or severe injuries.
· Do not use this product in swimming pools, jacuzzis, whirlpools, etc.
Adhere to the following conditions for dry installation:
5 B
· Ensure that the connection to the power supply is at least 2 m from the pond.
· Only install the unit below water level.
· Set up the device horizontally on a firm, mud-free surface.
· Install the unit max. 0.5 m below the water surface.
How to proceed:
5 C
1. Set the desired bubbling intensity on the water lily valve.
– To increase the bubbling intensity: Turn the valve clockwise.
– To reduce the bubbling intensity: Turn the valve counter-clockwise.
2. Place the unit and the artificial water lily in the water.
– The artificial water lily floats on the surface of the water.
3. Route the connection cable to the socket.
4. Start up the unit. (→ Commissioning/start-up)
Commissioning/start-up
N O T E
The unit will be destroyed if it is operated with a dimmer. It contains sensitive electrical components.
· Do not connect the unit to a dimmable power supply.
N O T E
Prevent the pump from running dry. Otherwise the pump will be destroyed.
· Only operate the pump when it is immersed.
· Switching on: Insert the power plug into the socket.
– The unit switches on immediately.
· Switching off: Disconnect the power plug.
· When the unit is activated, the LED ring is lit and the pump runs.

Remedy of faults

Malfunction
LEDs are not lit
Insufficient bubbling intensity.
Insufficient or no pump delivery.
12
Cause
No mains connection
Connection defective
Valve soiled
Air hose kinked or porous
The pump filter housing is soiled.
The impeller unit is blocked.
The impeller unit is worn.
Remedy
Connect the connection cable to the mains.
Check the electrical connection.
Clean the valve.
Replace the air hose.
Clean the pump filter housing.
Clean the pump.
Replace the impeller unit.