Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Heating System and Pilot Light Operation
• The Therabath is equipped with 2 thermostats. The Control Thermostat
automatically heats and maintains the paraffin at 130 degrees F (54.4 C)
with ± 4 degrees F variation. If the Control Thermostat fails, the High
Limit Thermostat automatically shuts off the unit completely. Return to
manufacturer for servicing.
• The pilot light (on end of unit) indicates the unit is heating, and is lit only
during the heating cycle. During normal operation, the pilot light goes
on and off at regular intervals. Most of the time it is off.
• If the unit is not completely melted after being plugged in for 12 hours,
follow troubleshooting steps at therabath.com/service.
Operating Instructions
1. Unpack the unit and place it on a flat, secure surface.
2. Open the included bags of paraffin and place the
contents inside the tank.
3. Place the plastic grille on TOP of the un-melted paraffin.
4. Rest the lid on top of the paraffin and grille. The paraffin
will compact as it melts.
5. Plug the unit in.
6. The paraffin will melt in about 6 to 8 hours.
7. Keep the unit plugged in continuously so that it is
always ready for use.
Adding Refill Paraffin
1. Keep the paraffin level to the desired level: 6lb -
standard usage, 8lb - max. deep immersion foot level, 9lb - max. deep immersion hand level. Do not
overfill the unit.
2. For optimal performance use only Therabath brand refill paraffin.
Treatment Guidelines
• Refer to contraindications before use.
• Cleanse and dry the skin before applying paraffin.
• Keep clothing and jewelry away from the treatment area.
• Do not remelt used paraffin, discard.
• Keep the lid on when unit is not in use.
1. Apply Pre-Treatment Cleansing Spray.
eyes, nose, or mouth.)
2. Apply Hydrating Cream.
3. Slowly dip hand, foot, or elbow into the bath. Use paraffin
application strips for other treatment areas.
4. Remove and wait a few seconds until the shine goes away. Repeat 3 to 10 times.
5. Cover hand or foot with a plastic liner.
6. Slip on an insulated mitt or boot to retain heat.
7. Keep paraffin in place for 10 to 15 minutes.
8. Remove. Discard used paraffin and plastic liner (if used).
††
OPTIONAL: Pre-Treatment Cleansing Spray, Hydrating Cream, paraffin application strips,
plastic liners, mitts, boots, and more are sold separately. Call your dealer or visit www.
therabath.com.
Cleaning Instructions
• Clean paraffin bath when noticeable sediment accumulates on the tank bottom.
• Do not scratch or damage the inside tank coating.
• Do not immerse the unit in water.
• Do not use abrasive scouring powders of any kind when cleaning the tank.
1. Unplug the unit. Remove the grille. Allow the paraffin to solidify.
2. After the paraffin is solid, plug in unit and tip upside down on a wax-safe surface for approximately
15-20 min. until the paraffin loosens from the tank and falls out. Unplug the unit.
3. Remove remaining paraffin in the tank with soft paper towels.
4. Refill with Therabath
(Do not use spray near the
††
††
††
®
brand paraffin.
††
• 3 / 12 •
Publicité
Table des Matières
