Operating Instructions - Exquisit EH 51001 swg Manuel Du Propriétaire

Fix the wall hanging holder on the wall by using the three 4*45mm screws
Figure 1
Put the electric fireplace back bracket aligned with the wall bracket, as shown in
Figure 1. Place the holes on both sides of the wall bracket aligned to the holes on
both sides of the inner movement, then fix it by 4*12mm screws. The heater is
installed in good condition as show in figure 2.

OPERATING INSTRUCTIONS

1. Firstly, turn on the power switch on the right side of the fireplace, which can
provide the power supply to all the function of the fireplace. Only in the state of
mode I, the function will be operated, including the using of remote control.
Press the power key on the remote control, at this time is to open
the heating function and flame effect. Then press the power key,
the heating function and flame effect will stop work , and enter
standby state.
Insert
card slot
29
Figure 2
Screw
tighten